
1. CREATING MACHINING
PROGRAMS FOR TWO–PATH
4–AXIS(X1, Z1, X2, AND Z2) LATHES
B–63284EN/03
EXAMPLES OF CREATING
PROGRAMS
506
When the machine stroke is too large to compensated for by the geometry
compensation amount, the workpiece shift amount is used for
compensation as shown in the following example:
Example) When the tool geometry compensation is insufficient
Tool post
(machine zero
point)
Origin of the workpiece coordinate system
(on the end surface of the chuck)
Chuck
Workpiece
Z
go
(Tool geometry compensation along the Z–axis)
Tail stock
X
go
When the stroke along the Z–axis of the machine exceeds the maximum
value (999.999 mm in metric system) of the tool geometry compensation
amount (Zgo), assign the machining workpiece length value and other
values as the workpiece shift amount along the Z–axis. Then, place the
virtual reference position on the workpiece end face. The Z–axis tool
geometry compensation amount will then be able to be within the
maximum value.
Tool post
(machine zero
point)
Origin of the workpiece coordinate system
(on the end surface of the chuck)
Chuck
Workpiece
Z
ws
(Workpiece shift amount along the Z–axis)
Tail stock
X
go
Virtual zero point
Z
go
NOTE
Some machine tool builders use the workpiece shift amount
for purposes other than the above. In such a case, the data
setting method differs from this. Refer to the manual
prepared by each machine tool builder.
1.4
SETTING UP
MACHINING
1.4.1
Setting the Workpiece
Shift Amount