
1. MACHINING PROGRAMS FOR
2–AXES (X AND Z–AXIS) LATHES
B–63284EN/03
TYPES OF MACHINING
PROGRAMS
378
Amount of retraction
1. Peck drilling
2. High–speed peck drilling
Cutting start point
Cutting start point
Amount of each cut
Amount of each cut
Amount of retraction
JMIN DEPTH : Minimum depth of cut. (Related parameter: No.
9852, DRLMIN)
JSTART FEED : Cutting feed amount at the start of cutting.
(Related parameter: No. 9050, STFECF). The
cutting feed amount at the start of cutting is
calculated as follows. It can be changed manually.
(STFECF)
100
(Usual cutting feed amount) ×
JSTART CLR : Clearance (distance between the tool tip and tool
shoulder) at the start of cutting. The tool cuts the
workpiece by the cutting feed amount at the start of
cutting, described above, from a point distanced
from the cutting start point by an amount equal to
this clearance. This clearance is calculated as
follows. It can be changed manually.
SC=
(θ=Tool angle between 0<θ <180°)
(nominal diameter of the tool)
2 x Tan ( θ/2)
SC
θ
JEND FEED (only for a through hole):
Cutting feed amount for the last cut. (Related
parameter: No. 9051, ENFECF). The cutting feed
amount for the last cut is calculated as follows. It
can be changed manually.
(ENFECF)
100
(Usual cutting feed amount) ×