
B–63284EN/03
2. B–AXIS
CONVERSATIONAL
PROGRAMMING
ADDITIONAL FUNCTIONS OF SERIES
BH1E/BH2E/BH3E AND BH1F/BH2F/BH3F
658
For the machining types listed below, TILT can be set as the machining
area. When TILT is set, the data items TILT:CP–X, TILT:CP–Z, and
TILT:ANGL appear on the list screen. (Initially, TILT:CP–X and
TILT:CP–Z are set to 0.0, and TILT:ANGLE is set to 0.0.)
C–axis center drilling, C–axis drilling, C–axis tapping
Y–axis center drilling, Y–axis drilling, Y–axis tapping, Y–axis milling
In TILT:CP–X and TILT:CP–Z, enter the center point of the rotation of
the workpiece coordinate system in terms of coordinates in the program
coordinate system.
In TILT:ANGLE, enter the angular displacement around the Y–axis at the
tilt center. The angle is positive in the right–hand thread turning direction
when viewed from the negative side of the Y–axis toward the positive
side.
You cannot leave these data items blank.
In TILT:ANGL, a value greater than –90.0 and smaller than or equal to
0.0 can be entered.
If TILT:ANGL is set to 0, three–dimensional conversion is not performed,
and the same operation as side–face machining with CROSS specified as
the machining area takes place.
For TILT, enter a machining profile on the Y’Z’ plane.
When TILT is set as the machining area, the tool to be selected
automatically is selected from side–face machining tools. Also when
selecting a tool manually, select it from side–face machining tools.
2.3
OPERATION
SPECIFICATIONS
2.3.1
Program Screen