
2. MACHINING PROGRAMS FOR
LATHES WITH C–AXIS
B–63284EN/03
TYPES OF MACHINING
PROGRAMS
436
Blank
Notch
End–face end mill
X
Z
C–axis
End face of
a blank
To enable this machining, set the following parameter:
#7
CML9764
#6 #5 #4 #3 #2 #1 #0
CML 1 : Enables C–axis milling.
0 : Disables the above function.
NOTE
When this function is enabled, C–axis cylindrical machining
cannot be selected.
Along the contour specified in figure data, C–axis end face milling is
performed only once with the end face end mill tool. Input the contour
along which the tool should move. In–feed machining is not performed
in the Z direction.
When the cursor is positioned to the end of a program, a new process is
created automatically, and the machining type soft key menu is displayed.
Press [C–MIL] and then [FACING] to select a C–axis end face milling
process.
NOTE
When non–zero data is input for a chamfering amount, a
chamfering process is created automatically, as shown
below.
2.8
C–AXIS END FACE
MILLING
2.8.1
Selecting the
Machining Type