B–64113EN–1/01
14. MEASUREMENT
985
5020 Tool offset number used for the input of tool offset value measured B
[Data type] Byte
[Valid data range] 0 to the number of tools to be compensated.
Set tool offset number used for the input of tool offset value measured B
function (i.e. when workpiece coordinate system shift value is set). (The
tool offset number corresponding to the measured tool shall be set in ad-
vance.) This parameter is valid when the tool offset number is not selected
automatically (QNI, #5 of parameter 5005, is zero).
5021 Number of pulse interpolation cycles memorized prior to contacting the touch sensor
[Data type] Byte
[Unit of data] Interpolation cycle
[Valid data range] 0 to 8
This parameter sets the number of pulse interpolation cycles to be
memorized until the operator manually touches the tool with a
one–contact input touch sensor when the tool offset measurement value
direct input B function is used.
If 0 is set for this parameter, the specification of 8 (maximum allowable
value) is assumed.
NOTE
This parameter is enabled when the TS1 parameter (bit 3
of parameter No.5004) is set to 1.
Number Message Description
5195 DIRECTION CAN NOT BE
JUDGED
For a one–contact input touch sensor
used with the tool compensation
amount measurement value direct in-
put B function, stored pulse directions
are not unified.
S The machine is at a stop in the offset
write mode.
S The servo power is off.
S Pulse directions are diverse.
Alternatively, the tool is moving along
two axes (X–axis and Z–axis) simulta-
neously.
Series 0i–C
OPERATOR’S MANUAL
(T series) (B–64114EN)
III.11.4.3
Direct Input of Tool Offset Mea-
sured B
Series 0i Mate–C
OPERATOR’S MANUAL
(T series) (B–64134EN)
III.11.4.3
Direct Input of Tool Offset Mea-
sured B
Alarm and message
Reference item