
B–64113EN–1/01
1. AXIS CONTROL
41
In bidirectional pitch error compensation, different pitch error
compensation amounts can be set for travel in the positive direction and
that in the negative direction, so that pitch error compensation can be
performed differently in the two directions, in contrast to stored pitch
error compensation, which does not distinguish between the directions of
travel. In addition, when the direction of travel is reversed, the
compensation amount is automatically calculated from the pitch error
compensation data to perform compensation in the same way as in
backlash compensation. This reduces the difference between the paths in
the positive and negative directions.
1. Setting parameters
Set the following parameters for each axis.
Table 1.3.3 (a)
Data number Description
3605#0 Bidirectional pitch error compensation,
1: Enabled / 0: Disabled
3620 Number of the pitch error compensation point of the refer-
ence position
3621 Number of the most distant pitch error compensation point
on the – side for travel in the positive direction
3622 Number of the most distant pitch error compensation point
on the + side for travel in the positive direction
3623 Pitch error compensation magnification
3624 Pitch error compensation point interval
3625 For a rotation axis, amount of travel per rotation in pitch
error compensation
3626 Number of the most distant pitch error compensation point
on the – side for travel in the negative direction
3627 Pitch error compensation amount (absolute value) at the
reference position when the machine moves to the refer-
ence position in the direction opposite to that of a reference
position return
2. Pitch error compensation data
The compensation point numbers can be from 0 to 1023 and from 3000
to 4023. This data may be used for both the positive and negative
directions. Note, however, that the set of compensation data for a given
axis cannot extend over 1023 and 3000.
1.3.3
Bidirectional Pitch
Error Compensation
Outline
Setting data