B–64113EN–1/01
4. REFERENCE POSITION ESTABLISHMENT
237
Number Message Description
046
ILLEGAL REFERENCE RE-
TURN COMMAND
Other than P2, P3 and P4 are commanded
for 2nd, 3rd and 4th reference position re-
turn command.
Correct program.
CAUTION
1 If the G30 command is issued in machine lock status, the
completion signal for 2nd, 3rd, or 4th reference position
return is not set to 1.
2 If millimeter input is selected for an inch–system machine,
the completion signal for 2nd, 3rd, or 4th reference position
return may be set to 1, even when the programmed tool
position deviates from the 2nd, 3rd, or 4th reference position
by the least input increment. This is because the least input
increment is smaller than the least command increment for
the machine.
OPERATOR’S MANUAL
(M series) (B–64124EN)
II.6 REFERENCE POSITION
OPERATOR’S MANUAL
(T series) (B–64114EN)
II.6 REFERENCE POSITION
OPERATOR’S MANUAL
(M series) (B–64144EN)
II.6 REFERENCE POSITION
OPERATOR’S MANUAL
(T series) (B–64134EN)
II.6 REFERENCE POSITION
Alarm and message
Caution
Reference item