
B–64113EN–1/01
9. SPINDLE SPEED FUNCTION
579
[Classification] Output signal
[Function] This signal indicates that a reference position return has been made for the
Cs contour control axis.
[Output condition] If a manual reference position return or automatic reference position
return by G28 is performed during the Cs contour control mode, this
signal becomes logical 1 when the Cs contour control axis reaches the
reference position.
Feed axis and direction select signal +Jn, *Jn <G100, G102> (Input)
Manual handle feed axis select signal HSnA, HSnB, HSnC, HSnD
<G018, G019> (Input) (Refer to respective items in this manual)
The Cs contour control axis can be manually operated in the same way as
normal servo axes, except for a manual reference position return. In the
spindle speed control mode, however, manual operations for the Cs
contour control axis must be inhibited using the PMC ladder, etc.
[Classification] Input signal
[Function] These signals select the axis for which fine acceleration/deceleration is to
be disabled during Cs contour control mode.
[Operation] 0: No fine acceleration/deceleration is disabled for the corresponding
axis during Cs contour control mode.
1: Fine acceleration/deceleration is disabled for the corresponding axis
during Cs contour control mode.
*1 These signals take effect immediately when they are entered. Do
not use the signals during axis movement, or the machine will
undergo shocks.
*2 These signals take effect during Cs contour control mode if
parameter CSL (bit 6 of parameter No. 3710) = 0.
Cs contour control axis
reference position return
completion signal
ZPx <F094>
Signals on manual
operation
Cs contour control mode
fine acceleration/
deceleration disable
signals
CDF1 to CDF4
<G0127#0 to G0127#3>