
B–64113EN–1/01
9. SPINDLE SPEED FUNCTION
531
NOTE
1 Type M:
The gear selection signal is not entered externally. In
response to an S command, the CNC selects a gear
according to the speed range for each gear specified in
parameters. Then the CNC reports the selection of a gear
by outputting the gear selection signal. The spindle speed
corresponding to the gear selected by the gear selection
signal is output.
Type T:
The gear selection signal is entered from the PMC. The
spindle speed corresponding to the gear selected by this
signal is output.
2 When the constant surface speed control is selected, type
T is selected, regardless of whether this parameter is
specified.
3 When type T spindle gear switching is selected, the
following parameters have no effect:
No. 3705#2 SGB, No. 3751, No. 3752, No. 3705#3 SGT,
No. 3761, No. 3762, No. 3705#6 SFA, No. 3735, No. 3736
However, parameter No. 3744 is valid.
ORM Voltage polarity during spindle orientation
0 : Positive
1 : Negative
TCW, CWM Voltage polarity when the spindle speed voltage is output
TCW CWM
Voltage polarity
0 0 Both M03 and M04 positive
0 1 Both M03 and M04 negative
1 0 M03 positive, M04 negative
1 1 M03 negative, M04 positive
#7
3708
#6
TSO
#5 #4 #3 #2 #1 #0
[Data type] Bit
TSO During a threading or tapping cycle, the spindle override is:
0 : Disabled (tied to 100%).
1 : Enabled.
NOTE
The operation during rigid tapping depends not only on this
parameter but on the setting of rigid tapping.