
15. PMC CONTROL FUNCTION
B–64113EN–1/01
1040
Read signal for external data input
(ESTB)
Read completion signal for external
data input (EREND)
If RST becomes 1 even momentarily in this
period
Reset signal
(RST)
Search completion signal for external
data input (ESEND)
ESEND does not become high.
Search cancel signal for external
data input (ESCAN)
ESCAN becomes high at the beginning of a search
ESTB positive–going edge
Beginning of search
NOTE
1 The external program number search is valid when
parameter ESR no. 6300#4=1.
2 In reset state the automatic operation lamp will be off. If the
start button is pushed in the cycle operation stop or hold
state, search execution starts from the actual position
indicated by the pointer.
3 When there is no program stored in memory corresponding
to the set program number, P/S alarm no. 59 will be
activated.
4 Program search is not made if the program number is set to
“0”. Insteadly when the start button is pushed, execution
starts from the position indicated by the pointer.
5 Data for the external program number search is accepted
regardless of the mode, but the search execution can be
made only in the reset state. Therefore, in case that the
PMC sequence, which the cycle start is executed by
checking search completion signal for external data input
only, is used, if the external program number search is
commanded twice, the program is executed twice. (When
CNC accepts a command of the program number search,
the command is not cancelled even if CNC becomes reset
state by external reset signal and so on.) (See Fig. 15.2)
If the program execution after reset becomes a problem,
please make the PMC sequence not to execute the cycle
start after reset.