
12. DISPLAY/SET/EDIT
B–64113EN–1/01
876
#7
13600
#6 #5 #4 #3 #2 #1 #0
MCR
[Data type] Bit
MCR When the permissible acceleration is adjusted with the machining
condition selection function (machining parameter adjustment screen or
precision level selection screen), parameter Nos. No.1730 and 1731,
which are related to feedrate clamping by arc radius, are:
0 : Changed.
1 : Not changed.
#7
13601
#6 #5 #4 #3 #2 #1 #0
MPR
[Data type] Bit
MPR The machining parameter adjustment screen is:
0 : Displayed.
1 : Not displayed.
NOTE
1 When this parameter has been set, the power must be
turned off before operation is continued.
2 Even when this parameter is set to 1, the precision level
selection screen is displayed.
13610
Acceleration rate of acceleration/deceleration before interpolation when advanced
preview control, AI advanced preview control, or AI contour control is used
(precision level 1)
13611
Acceleration rate of acceleration/deceleration before interpolation when advanced
preview control, AI advanced preview control, or AI contour control is used
(precision level 10)
[Data type] 2–word
[Unit of data] %
Increment system Unit
Millimeter machine 0.001mm/sec
2
[Valid data range] 50000 to 99999999
These parameters set the acceleration rate of acceleration/deceleration
before interpolation in advanced preview control, AI advanced preview
control, or AI contour control. Two levels including precision level 1,
which places emphasis on speed, and precision level 10, which places
emphasis on precision, can be set.
Parameter