18. TROUBLE DIAGNOSIS
B–64113EN–1/01
1100
[YES]/[NO]: Check contents of guidance message, and, answer by
pressing soft key [YES] or [NO]. Then the next guidance
message is displayed.
In some cases CNC automatically checks and judges
contents of guidance. In this case the next guidance
message is automatically displayed.
Automatic diagnosis is not done in case that CNC power
turns off once after servo /spindle monitor information is
memorized.
[BACK]: Guidance message returns back 1 step.
It is possible to trace back the guidance message when
[YES]/[NO] is pressed by mistake.
[RESUME]: Guidance message which was displayed before CNC
power tured off is displayed agein.If guidance is not done
once, soft key [RESUME] does not appear. It is not
possible to go back to the step before the point where soft
key [BACK] is pressed.
Status display [RESUMING] is displayed during the
guidance that starts by pressing [RESUME].
When several alarms occur in same time, pressing page key
[Page↓]/[Page↑] can select the guidance message.
Operation
Change of Guidance
Change of alarm