10. TOOL FUNCTIONS
B–64113EN–1/01
718
Number Message Description
033 NO SOLUTION AT CRC A point of intersection cannot be deter-
mined for cutter compensation C.
Modify the program.
034 NO CIRC ALLOWED IN
ST–UP /EXT BLK
The start up or cancel was going to be
performed in the G02 or G03 mode in
cutter compensation C. Modify the pro-
gram.
035 CAN NOT COMMANDED
G39
G39 is commanded in cutter com-
pensation B cancel mode or on the
plane other than offset plane. Modify
the program.
036 CAN NOT COMMANDED
G31
Skip cutting (G31) was specified in cut-
ter compensation mode.
Modify the program.
037 CAN NOT CHANGE
PLANE IN CRC
G40 is commanded on the plane other
than offset plane in cutter compensa-
tion B. The plane selected by using
G17, G18 or G19 is changed in cutter
compensation C mode. Modify the pro-
gram.
038 INTERFERENCE IN CIR-
CULAR BLOCK
Overcutting will occur in cutter com-
pensation C because the arc start point
or end point coincides with the arc cen-
ter.
Modify the program.
041 INTERFERENCE IN CRC Overcutting will occur in cutter com-
pensation C. Two or more blocks are
consecutively specified in which func-
tions such as the auxiliary function and
dwell functions are performed without
movement in the cutter compensation
mode. Modify the program.
042 G45/G48 NOT ALLOWED
IN CRC
Tool offset (G45 to G48) is commanded
in cutter compensation. Modify the pro-
gram.
5257 G41/G42 NOT ALLOWED
IN MDI MODE
G41/G42 (cutter compensation C: M
series, tool–nose radius compensa-
tion: T series) was specified in MDI
mode. (Depending on the setting of bit
4 of parameter No. 5008)
Series 0i–C
OPERATOR’S MANUAL
(M series) (B–64124EN)
II.14.4,
14.5
Cutter compensation C
Series 0i Mate–C
OPERATOR’S MANUAL
(M series) (B–64144EN)
II.14.4,
14.5
Cutter compensation C
Alarm and message
Reference item