B–64113EN–1/01
10. TOOL FUNCTIONS
695
#7 #6 #5 #4 #3 #2 #1 #0
5002 LGN LD1
[Data type] Bit
LD1 Wear offset number of tool offset
0 : Specified using the lower two digits of a T code
1 : Specified using the lower one digit of a T code
LGN Geometry offset number of tool offset
0 : Is the same as wear offset number
1 : Specifies the geometry offset number by the tool selection number
#7 #6 #5 #4 #3 #2 #1 #0
5006 TGC
[Data type] Bit
TGC When a T code is specified in a block containing G50, G04, or G10:
0 : No alarm occurs.
1 : P/S alarm No. 254 occurs.
Number Message Description
030 ILLEGAL OFFSET NUM-
BER
(T series)
The offset number in T function speci-
fied for tool offset is too large.
Modify the program.
043 ILLEGAL T–CODE COM-
MAND
(M series)
In a system using the DRILL–MATE
with an ATC, a T code was not specified
together with the M06 code in a block.
Alternatively, the T code was out of
range.
245 T–CODE NOT ALOWED
IN THIS BLOCK
(T series)
One of the G codes, G50, G10, and
G04, which cannot be specified in the
same block as a T code, was specified
with a T code.
Alarm and message