
B–64113EN–1/01
7. FEEDRATE CONTROL/ACCELERATION
AND DECELERATION CONTROL
415
1769
Time constant of linear acceleration/deceleration or bell–shaped acceleration/
deceleration after interpolation in cutting feed for each axis in advanced
preview control, AI advanced preview control, or AI contour control mode
[Data type] Word axis
[Unit of data] msec
Advanced preview control, AI advanced prevoew control 0, 8 to 512
AI contour control 0, 4 to 256
Set the time constant to be used for linear or bell–shaped
acceleration/deceleration after interpolation in cutting feed in advanced
preview control, AI advanced preview control, or AI contour control
mode for each axis. Which acceleration/deceleration type, the linear or
bell–shaped type, is to be used is specified by bit 3 (BS2) and bit 6 (LS2)
of parameter No. 1602.
NOTE
1 If 0 is set in parameter No. 1769 for all axes, the value set
in parameter No. 1768 is used. For other than special
purposes, set a time constant in parameter No. 1768, which
is common to all axes.
2 If a different time constant is set in parameter No. 1769, a
correct straight line or arc shape cannot be obtained.
1770
Parameter 1 for setting the acceleration rate of linear acceleration/deceleration
before interpolation in advanced preview control, AI advanced preview control, or
AI contour control mode (maximum machining speed during linear acceleration/
deceleration before interpolation)
[Data type] 2–word
Valid data range
y
IS-A, IS-B IS-C
Millimeter machine 1 mm/min 6 to 240000 6 to 100000
Inch machine 0.1 inch/min 6 to 96000 6 to 48000
This parameter is used to set the acceleration rate of linear
acceleration/deceleration before interpolation in advanced preview
control, AI advanced preview control, or AI contour control mode. In this
parameter, set the maximum machining speed during linear
acceleration/deceleration before interpolation. Set the time used to reach
the maximum machining speed in parameter No.1771.
[Valid data range]
[Unit of data]
[Valid data range]