
B–61863E/15
B. WINDOW FUNCTION DESCRIPTION
(PMC–PA1/PA3/SA1/SA2/SA3/SA5/SB/
SB2/SB3/SB4/SB5/SB6/SB7/SC/SC3/SC4)
APPENDIX
1173
(1) Overview
PMC application programs can read CNC alarm information.
(2) Alarm information
1) Alarm status
Information concerning the alarm type
2) Detailed alarm
Information concerning the alarm number and axis information
NOTE
When detailed alarm is read in the Power Mate i–D/H, use
”B.4.83 Reading Detailed Alarm Information (*Low–speed
type)”.
(3) Input data configuration
Top address+0 +2 +4 +6 +8 +10
Function Completion Data Data Data Data
code code length number attribute area
Function code : 23 (fixed)
Completion code : No specification required.
Data length : No specification required.
Data number : Number of alarms which can be stored. (Up to 30).
If 31 or more are specified, the value is assumed to
be 30.
Data area : No specification required.
Data attribute : 0 : Alarm status information
Other than 0 : Detailed alarm information,
indicated in two–byte bit–type data
described below (multiple bits can
be specified.)
151413121110 9876543210
bit
Bit 0 : P/S alarm 100 (PS1)
(PWE, parameter write enable, is set to 1.)
Bit 1 : P/S alarm 000 (PS2)
(Turn off the power. Writing data into certain parameters may
cause this alarm.)
Bit 2 : P/S alarm 101 (PS3)
(Part program storage has been disrupted. This alarm is issued
when the CNC is turned off during tape editing or machining
program reading. To release this alarm, press the RESET key
while holding down the PROG key.)
B.4.12.2
For Power Mate–D/F/H
(Low–speed type)