
11. INTERRUPT–TYPE
PMC FUNCTION
B–61863E/15
PMC SEQUENCE PROGRAM
410
Continuous interrupt processing
After the interrupt program has been started by a certain interrupt signal,
if another interrupt signal occurs, it is processed after the current interrupt
processing is completed.
(Example) Rising edges of bits 0 and 1 of X1003
Interrupt input signal
(X1003.0)
Interrupt program
Interrupt input signal
(X1003.1)
Executed later
Fig. 11.3.6 (a) Continuous interrupt operations triggered
by different signals
After the interrupt program has been started by a certain interrupt signal,
if the same interrupt signal occurs again, it is ignored.
(Example) Rising edge of bit 0 of X1003
Interrupt input signal
(X1003.0)
Interrupt program
This interrupt
request is
ignored.
Fig. 11.3.6 (b) Continuous interrupt operations triggered
by the same signal
If both the rising and falling edges of a certain interrupt input signal are
specified for interrupt, the falling (rising) edge is ignored if it is detected
during the interrupt program execution requested on the rising (falling)
edge. So, it is necessary to complete the interrupt program execution
before the interrupt input signal changes.