
B–61863E/15
1. GENERALPMC PROGRAMMER (CRT/MDI)
509
1
GENERAL
This PMC programmer is used to set PMC system parameters and also
generate and execute sequence programs by using soft keys on the
CRT/MDI panel. For this operation, the PMC debugging RAM must be
mounted in the CNC in advance.
For the CRT/MDI panel keys, refer to PMC operation in PARTII, Chapter
1 and 2.
1) Setting and display of PMC system parameters (SYSPRM)
The following system parameters are available.
a) Selection of counter data types (BCD or binary)
b) Selection of division/non–division of ladder program (only
PMC–SC)
c) Parameters for executing C language programs (only for
PMC–SC)
2) Editing of sequence programs (EDIT)
The following editing functions are provided.
a) Clear of memory
b) Title data input
c) Input, insert, search, and delete of sequence programs by ladder
diagram format
d) Input, insert, delete, and search of symbol data
e) Address setting to each module when I/0 unit is used
f) Message data input
3) Execution of sequence programs (RUN/STOP)
The following function is provided to execute sequence programs
a) Sequence program start and stop
4) To write, verify, and read of sequence programs and PMC data, and
to write and read of I/0 sequence programs, followings are provided.
a) Input/output of sequence programs to and from FANUC floppy
disk cassette
b) Input/output of sequence programs to and from debugging RAM
c) Input/output of sequence programs to and from ROM
d) Input/output of PMC parameter data to and from FANUC FD
cassette
5) Displaying the contents of memory for the user C program and
debugging the user C program (MONIT)
a) Displaying the GDT map of the user C program
b) Displaying memory information for the user C program
c) Debugging the user C program