
B–61863E/15
K. LEVEL UP OF INPUT/OUTPUT FUNCTION
WITH MEMORY CARD
APPENDIX
1521
The function is leveled up, that is Input/Output function with Memory
Card by CNC or Offline Programmer. The leveled up contents are as
follows.
(1) The time is reduced in Inputing/Outputing between CNC and
Memory Card by PMC I/O function. This is the same between
Offline Programmer and Memory Card.
(2) Sequence programs can be inputted from Memory Card by BOOT
SYSTEM, by which CNC management software or so can be
inputted.
Memory Card function can be used in the following editions of CNC
basic software and PMC management software and FANUC
LADDER for Personal Computer.
· CNC basic software
non leveled up leveled up
FANUC Series 20–FA basic software (D001) 05–06 More than 07
FANUC Series 20–TA basic software (D101) 02 More than 03
· PMC management software
non leveled up leveled up
PMC–SA1/SA3 management software (4080) 04–05 More than 06
· FANUC LADDER for Personal Computer
non leveled up leveled up
FANUC LADDER PMC–SA1/SA2/SB/SB2/SC
SYSTEM
(A08B–9200–J502#JP (PC–9801))
(A08B–9201–J502#EN (IBM PC/AT))
6.1 6.2 More than 6.3
PMC–SA1/SA2 MODULE
(PMC–SA1/SA2/SA3/PA1/PA3)
(A08B–9200–J603#JP (PC–9801))
(A08B–9201–J603#EN (IBM PC/AT))
4.1 More than 4.2
K.1
OUTLINE OF
LEVELED UP
CONTENTS