
5. FUNCTIONAL INSTRUCTIONS
B–61863E/15
PMC SEQUENCE PROGRAM
336
[For direct gear selection]
The sequence program sets the gear to be used in GR1 to GR4.
This functional instruction calculates the spindle motor rotation
commands for all speeds from the upper motor speed limit to the
lower speed limit (extended portion indicated by dotted line). See
Fig. 5.63.1.
(ii) Spindle motor rotation command
76543210
R08 R07 R06 R05 R04 R03 R02 R01
R13 R12 R11 R10 R09
The spindle motor rotation command (13–bit binary data)
calculated by this functional instruction is set at these control data
addresses. This instruction specifies a spindle motor rotation
command with a spindle override applied.
(iii) Spindle override
76543210
SOV128 SOV64 SOV32 SOV16 SOV8 SOV4 SOV2 SOV1
The sequence program must set a spindle override in binary. A
spindle override from 0% to 255% can be set in binary.
Spindle control is primarily used to control the spindle speed during
normal cutting. It can, however, also be used to:
(a) Rotate the spindle motor at a specific speed when the gear is switched
The sequence program can output appropriate 13–bit binary data as
a spindle motor rotation command to rotate the spindle motor at a
specific speed, without using this functional instruction.
(b) Rotate the spindle at a specific speed during spindle orientation
This is enabled by specifying appropriate spindle speed data in the
functional instruction (SPCNT). During spindle orientation, the
spindle is rotated at the specified orientation spindle speed with the
currently selected gear (gear selection is not performed). Gear
selection is disabled by setting CIRC to 1 (direct gear specification).
Spindle motor
rotation command
Spindle
speed data
sent from
the NC, etc.
SPCNT
Spindle control
Information of
GR1 to GR2
Spindle speed data
Orientation
spindle
speed data
ȡ
ȧ
ȥ
ȧ
Ȣ
ȣ
Ȧ
Ȥ
ȡ
ȥ
Ȣ
5.63.5
Use of Spindle Control