
5. LADDER DIAGRAM EDITOR
FUNCTION (PMC–SB7)
B–61863E/15
FS16i/18i/21i/0i–B PMC–SA1/SB7 MANIPULATION
900
In Ladder Diagram Editor screen you can edit Ladder program to change
its behavior. To reach Ladder Diagram Editor screen, press [EDIT] soft
key at Ladder Diagram Monitor screen. Following operations are
available at Ladder Diagram Editor screen.
– Delete by net [DELETE]
– Move by net [CUT] & [PASTE]
– Copy by net [COPY] & [PASTE]
– Change address of contacts and coils ”bit address” + INPUT key
– Change parameters of functional instructions
”number” or ”byte address”+ INPUT key
– Add new net [CREATE]
– Change construction of net [MODIFY]
– Make changes effective [UPDATE]
– Abandon changes [RESTORE]
Fig. 5.1 Ladder Diagram Editor screen
CAUTION
1 You can edit a ladder regardless of whether the ladder is
running/stopping. But, when you are going to execute the
edited ladder, it is necessary to update the ladder. By exiting
Ladder Editor screen, or pressing [UPDATE] soft key, update
the edited ladder. As for the protection of the editing operation,
please refer to ”5.3 Example for setting parameters”.
2 If the power is turned off before the edited sequence program
is written to flash ROM, the result of the edit is erased.Use the
input/output screen to write the sequence program to flash
ROM. When K902#0 is set to 1, a confirmation message
appears at the termination of editing, asking whether to write
the sequence program to flash ROM.
5.1
LADDER DIAGRAM
EDITOR SCREEN