
B–61863E/15
8. WRITING, READING, AND COMPARING
SEQUENCE PROGRAMS AND
PMC PARAMETERS
PMC–NB6 MANIPULATION
799
When ”FLOPPY” or ”OTHERS” is selected for ”DEVICE”, the [PORT
SETING] soft key is displayed. When the key is pressed, the following
screen appears. The following gives a display example shown when
”OTHERS” is selected for ”DEVICE”.
This screen allows the setting of the communication data required for
communication using the RS–232C. Communication data can be set for
each of the two types of devices independently of the other.
Selected device type is displayed to ”DEVICE” menu on screen.
Explanation of each question
D CHANNEL
Check that an RS–232C cable is connected to the main board of the
control unit. Directly enter the number corresponding to the connected
connector.
1 .......... JD5A
2 .......... JD5B
D BAUDRATE
1200: Sets the baud rate to ”1200”.
2400: Sets the baud rate to ”2400”.
4800: Sets the baud rate to ”4800”.
9600: Sets the baud rate to ”9600”.
19200: Sets the baud rate to ”19200”.
D STOP BIT
1 BIT: Sets the number of stop bits to ”1”.
2 BIT: Sets the number of stop bits to ”2”.
D WRITE CODE
”WRITE CODE” is displayed when ”OTHERS” is selected for
”DEVICE”.
ASCII: Sets the output code to ”ASCII”.
ISO: Sets the output code to ”ISO”.
8.8
PORT SETTING
SCREEN