
B–61863E/15
H. CONNECTING THE OPERATOR’S
PANEL FOR FS 0 WITH FS16,
FS18, FS21, OR Power Mate
APPENDIX
1503
Specify the LED signals at PMC address R using the user PMC ladder
program in the form of a bit image. PMC management software changes
the bit image LED signals to the coded output signals. (See Tables H.3.4
(a), H.3.4 (b), and H.3.4 (c))
While 1 is written in a LED bit image, the relevant LED automatically
goes on. When 0 is written in the LED bit image, the relevant LED goes
off. All LEDs are off before the power is turned on.
A maximum of 200 ms is required before the LED goes on or off after 1
or 0 is written in a bit image in the PMC.
LED signal address (Ym: Table H.3.4 (a)) and the bit image addresses (Rl
to Rl+7: Tables H.3.4 (b), and H.3.4 (c)) can be defined using fixed
addresses or unused addresses as desired. (In Series 0, the LED signal
address is fixed to Y51. The bit image addresses are fixed to G242 and
after.)
Table H.3.4 (a) Key switch and LED signal addresses
#7 #6 #5 #4 #3 #2 #1 #0
Xn KD7 KD6 KD5 KD4 KD3 KD2 KD1 KD0
Xn+1
Xn+2 KST KA3 KA2 KA1 KA0
Ym LD7 LD6 LD5 LD4 LD3 LD2 LD1 LD0
Table H.3.4 (b) Bit Image addresses of key switch and LED signals
(for the small operator’s panel)
#7 #6 #5 #4 #3 #2 #1 #0
KEY/LED F3 F2 F1 D1 C1 B1 A1
Rk/Rl F4 D2 C2 B2 A2
Rk+1/Rl+1 D4 D3 C4 C3 B4 B3 A4 A3
Rk+2/Rl+2 F6 F5 D5 C5 B5 A5
Rk+3/Rl+3 F8 D6 C6 B6 A6
Rk+4/Rl+4 D8 C8 B8 A8 A7
Rk+5/Rl+5 F9 D9 C9 B9 A9
Rk+6/Rl+6 F10 D10 C10 B10 A10
H.3.4
LED Signals (Ym)