
B–61863E/15
5. SETTING MENU (SETING)PMC–NB6 MANIPULATION
695
D STOP BIT
1 BIT: The number of stop bits is set to 1.
2 BITS: The number of stop bits is set to 2.
D TIMER 1
The value in communication parameter timer 1 is displayed. The value
can also be entered, but its specification is usually not necessary.
D TIMER 2
The value in communication parameter timer 2 is displayed. The value
can also be entered, but its specification is usually not necessary.
D TIMER 3
The value in communication parameter timer 3 is displayed. The value
can also be entered, but its specification is usually not necessary.
D MAX PACKET SIZE
The maximum packet size for the communication parameter is
displayed. The size can also be entered, but its specification is usually
not necessary.
D RS–232C (status display)
The status of an RS–232C port is displayed.
INACTIVE: No RS–232C port is in use.
STOPPING: An RS–232C port is closed.
STARTING: An RS–232C port is open.
STAND–BY: An RS–232C port is waiting to be connected to
FANUC LADDER–II.
CONNECTED:An RS–232C port has been connected to FANUC
LADDER–II.
If the ladder editing package is included in the system configuration, the
F–BUS prompt menu appears above the RS–232C status display menu,
and the F–BUS status display menu appears below the RS–232C status
display menu.
D F–BUS (prompt)
USE: An F–BUS port can be connected to the ladder editing
package.
NOT USE: No F–BUS port will be connected to the ladder editing
package.
D F–BUS (status display)
The status of an F–BUS port is displayed.
INACTIVE: No F–BUS port is in use.
STOPPING: An F–BUS port is closed.
STARTING: An F–BUS port is open.
STAND–BY: An F–BUS port is waiting to be connected to
FANUC LADDER–II.
CONNECTED:An F–BUS port has been connected to FANUC
LADDER–II.
Soft key descriptions
[EMGSTOP]: Clicking this key causes communication to be
terminated. It is used if it is impossible to terminate a
connection due to abnormal communication.
[INIT]: Clicking this key initializes the parameter settings.