
3. DISPLAYING PMC INPUT/OUTPUT
SIGNALS AND INTERNAL RELAY
(PMCDGN)
B–61863E/15
PMC–NB6 MANIPULATION
656
Soft keys display when the cursor is put on ”SAMPLING
CONDITION”.
Explanation:
TRIGGER Samples the status of specified signals when
the specified sampling condition is on.
ANY CHANGE Samples the status of specified signals when
the signals change
The address of the signals that should be sampled is set on Parameter
Setting screen page2.
D SAMPLING CONDITION TRIGGER ADDRESS
When ”SIGNAL TRANSITION” is set on ”TRACE MODE”, and
”TRIGGER” is set on ”SAMPLING CONDITION”, this parameter is
enabled. Input signal address or symbol name as sampling trigger.
Only bit address or corresponding symbol can be inputted. Byte
address cannot be inputted.
Soft keys display when the cursor is put on ”SAMPLING
CONDITION TRIGGER ADDRESS”.
The contents of the soft keys are same as ”STOP CONDITION
TRIGGER ADDRESS”.
D SAMPLING CONDITION TRIGGER MODE
When ”SIGNAL TRANSITION” is set on ”TRACE MODE”, and
”TRIGGER” is set on ”SAMPLING CONDITION”, this parameter is
enabled. Input trigger mode that determines the condition of specified
trigger.
Soft keys display when the cursor is put on ”SAMPLING
CONDITION TRIGGER MODE”.
Explanation:
RISING EDGE Samples the status of specified signals by
rising up of the trigger signal.
FALLING EDGE Samples the status of specified signals by
falling down of the trigger signal.
BOTH EDGE Samples the status of specified signals by
rising up or falling down of the trigger signal.
ON Samples the status of specified signals during
the trigger signal is on.
OFF Samples the status of specified signals during
the trigger signal is off.