
3. DISPLAYING PMC INPUT/OUTPUT
SIGNALS AND INTERNAL RELAY
(PMCDGN)
B–61863E/15
PMC–NB6 MANIPULATION
682
As for the override signal, the status of the override signal is set the
status of the signal just before pressing the soft–key [OVRIDE SET].
The bit set the override is added the ”→” display on the screen. The
actual signals before overridden are also displayed.
X address
(Actual input signal from the I/O devices)→(Overridden Input
signal to the ladder)
Y address
(Actual output signal from the ladder)→(Overridden output
signal to the I/O devices)
f. [OVRIDE RESET] Release of override signal
This releases the setting of override signal about the X/Y address
on the cursor.
The status of signal returns to the status before overridden by the
operation.
(a) Setting for bit
Move the cursor on the bit and press the soft–key [OVRIDE
RESET].
(b)Setting for byte
Move the cursor on the byte(all bit) and press the soft–key
[OVRIDE RESET].
g. [INIT] Release of all the overridden signals
This releases the setting of all override signals in X/Y addresses.
(2)Operations by other keys
a. Input key
This key is used to change the signal status.
(a) Setting for bit
D Input ”1” and press the input key to set into on.
D Input ”0” and press the input key to set into off.
D Simply press the input key to toggle the signal status on and
off.
(b)Setting for byte
Input the 8–digits binary and press the input key. (When the
number is less than 8, it is input from bit 0.)
Ex. : In the case of inputting ”100”, input as follows.
Bit No. 7 6 5 4 3 2 1 0
0 0 0 0 0 1 0 0
b. The cursor keys
Select the object of signal by the cursor keys. When pressing the
left cursor key on the ”bit 7” or the right cursor key on the ”bit 0”,
the cursor becomes the byte cursor. You can change the byte(whole
of bits) of the address.
c. The page keys
You can scroll the screen by these keys