
5. FUNCTIONAL INSTRUCTIONS
B–61863E/15
PMC SEQUENCE PROGRAM
288
Message characters not covered by the CRT/MDI keys (kanji and
half–width kana characters) can be input as follows:
(a) Half–width kana characters
(i) Data format
Numerical code enclosed by @ and @
(ii) Input method
Enter the numerical codes corresponding to the characters to be
input, by referring to the character code table (Table 5.44.6).
Each character requires two bytes. Characters covered by the
CRT/MDI keys can also be input in this way.
(iii) Example
To input ATC?
OK when characters A, T, C, O, and
K are registered in the CRT/MDI unit, enter the following:
NOTE
Spaces are used between each numerical code in example
to understand easily, but do not use them actually.
(b) Kanji (full–width) characters
Ę : Can be used
: Cannot be used
Power
Mate
FS20
FS21A
FS21B FS0i FS21i FS18A FS16A FS16B
FS18B
FS16C
FS18C
FS16i
FS18i
FS15B FS15i
PA1
PA3
SA1
SA3
SA1
SA3
SA1
SA3
SA1
SA5
SA1
SA3
SA2 SB
SB3
SB2 SC
SC3
SB3
SB4
SC3
SC4
SB5
SB6
SC3
SC4
SB5
SB6
SB7
NB NB2 NB6
f f f f f f f f f f f f
NOTE
1 The PMC–SA1 for the FS18–A can be used when the PMC management software series is
4071.
2 The PMC–SB for the FS16–A can be used when the PMC management software series is
4063.
3 The PMC–SC/SC3 for the FS16–A cannot be used depending on the series and edition of the
CNC software.
4 For the FS16–A, set the following CNC parameter:
– No. 6300 bit 6 = 0: Kanji characters are used for the DISPB instruction (default).
1: Kanji characters are not used for the DISPB instruction.
When kanji characters are used, the DISP instruction cannot be used.
5 On the CNC, the external data input option or external message option must be selected.
(i) Data format
Numerical code enclosed by @02 and 01@
(ii) Input method
Enter the numerical codes corresponding to the characters to be
input, by referring to the kanji, hiragana, and special code table
in Appendix P. Each character requires four bytes.
5.44.6
Defining Characters
not found in the
CRT/MDI