7
7.2 Parameter List
344
04144 Zero speed of the current loop integral gain
04145 Velocity factor of the current loop proportional
gain [%]
04146 Current conversion constant
04147 Secondary current factor for activating current
04148 Current expectation constant
04149 Slip constant
04150 High–speed rotation slip compensation
constant
04151 Compensation constant for voltage applied to
motor in the dead zone [%]
04152 Electromotive force compensation constant [%]
04153 Electromotive force phase compensation
constant [%]
04154 Voltage factor of the electromotive force
compensation [%]
04155 Voltage compensation factor during
deceleration
04156 Slip compensation gain
04157 Time constant for changing the torque [msec]
04158 Maximum output zero speed [min
–1
]
04159 Secondary current factor during rigid tapping
04160 Hysteresis of the speed detection level
04161 Constant for compensating for the phase of the
electromotive for at deceleration
04162 Velocity loop integral gain (High) in Cs contour
control cutting feed
04163 Velocity loop integral gain (Low) in Cs contour
control cutting feed
04164 Conversion constant of phase V current
04165 Time constant of voltage filter for eletro motive
force compensation
04166 Regenerative power limit
04167 Reserved
04168 Overload current alarm detection level
(for low speed characteristic)