7
7.2 Parameter List
442
08598 Maximum value of the operation range of the
ninth high–speed position switch or position
where the ninth high–speed position switch is
turned off [Detection unit]
PRM
8509#0
08599 Maximum value of the operation range of the
tenth high–speed position switch or position
where the tenth high–speed position switch is
turned off [Detection unit]
PRM
8509#1
74) Others
08650
Setting for C language executor
#0 RSK : Upon reset, key codes are not passed to the
application (0)/passed to the application (1).
#1 CNA : If an NC alarm is issued while the C executor
user screen is displayed, the screen is
changed according to PRM3111#7 (0)/is not
changed (1).
#2 EKY : When the C language executor is used, the
extended portion of the MDI keys (9 to 11
lines) is, not read (0)/read (1)
#3 DMA : When the C language executor is used,
transfer via RS–232–C is, not made as DMA
transfer (0)/made as DMA transfer (1)
#4 CKM : When the C language executor is used, the bit
matrix of the MDI keys is, not transferred to the
NC (0)/transferred to the NC (1)
#5 PGU : When the user screen for the C executor is
assigned as an NC program screen, the
common screen number is used (0)/the screen
number for each operation mode is used (1)
Usually set
0
08651 FACTOLINK software selection
#0 CFS : FACTOLINK software in, dedicated memory
card is valid (0)/FROM is valid (1)
08661 Size of the variable area of the C language
executor [KByte]
08662 Size of the SRAM disk of the C language
executor [KByte]
08663 Time zone used by the C language executor [s]
08700 Direct operation
#3 DMM: In DNC operation from the PMC, OPEN CNC
(HSSB), or C language executor, pre–reading
is, not performed (0)/performed (1)
DMMC
<G042#7>