19. MAINTENANCE FUNCTION
893
19.1.2.6 Outputting part program
1. Confirm the following parameters. If this parameter is set to 1, rather
than the value indicated by l, change to MDI mode and then reset to
0.
However, if you changed the parameter setting, restore the original value
after finishing this work.
#7
#6 #5 #4 #3 #2 #1 #0
3202
NE9 NE8
#0 (NE8) l 0 :Programs of 8000s are edited.
1 :Programs of 8000s can be protected.
#4 (NE9) l 0 :Programs of 9000s are edited.
1 :Programs of 9000s can be protected.
#7
#6 #5 #4 #3 #2 #1 #0
3204
P9E P8E
P8E Editing of subprograms 80000000 to 89999999 is:
l 0 :Not inhibited
1 :Inhibited
NOTE This parameter is valid when the program number O 8–digit option
is selected.
P9E Editing of subprograms 90000000 to 99999999 are:
l 0 :Not inhibited
1 :Inhibited
The following editing types become impossible.
NOTE This parameter is valid when the program number O 8–digit option
is selected.
2. Select EDIT mode.
3. Press
PROG
key and press soft key [PRGRM] to display program text.
4. Press [(OPRT)] key and press soft key
.
5. Input a program number to be output. To output all programs input as:
O – 9 9 9 9
6. Press [PUNCH] and [EXEC] key, then program output is started.
19.1.3 Input of data
19.1.3.1 Inputting CNC parameters
NOTE If an absolute pulse coder is attached, ALM300 is issued when a
CNC parameter is input. At this time, perform a reference position
return operation again.
Procedure
1. Set to the emergency stop state.
2. Confirm that the parameters required to input data is correct. (See
Subsec 19.1.1.)
3. Press soft key
.
4. Press soft key [READ] and [EXEC]. Then input of parameters are
started.