PROGRAMMING
B–63684EN/01
14. FUNCTIONS TO SIMPLIFY
PROGRAMMING
177
G98X–Y–I–J–P3K1 ;
U90 ;
|
V90 ;
G75W90Q–P5 ;
In the above program, products are machined in the order specified by the
following Q command.
(1)When machining restarts
(a) Q1 command: Products are machined in the order of E, F, G, and
H.
(b)Q2 command: Products are machined in the order of H, G, F, and
E.
(c) Q3 command: Products are machined in the order of D, C, and B.
(d)Q4 command: Products are machined in the order of B, C, and D.
(2)When machining starts
(a) Q1 command: Products are machined in the order of E, F, G, and H.
(b)Q2 command: Products are machined in the order of H, G, F, and
E.
(c) Q3 command: Products are machined in the order of D, C, B, and
A.
(d)Q4 command: Products are machined in the order of A, B, C, and
D.
WARNING
When restarting machining multiple products is specified,
the reference position specified by the G98 command for
setting the reference position used in machining multiple
products must be used. Do not change the reference
position.
NOTE
1 A restart command is invalid for trial machining.
2 When machining multiple products is restarted, specify the
position from which machining restarts using address P so
that the number of products includes the number of
products to be used for the trial, though they are not
machined.
3 If a setting specified with address P is not within the range
from 1 to the total number of products inclusive, alarm No.
4544 is issued.
Examples