APPENDIXG. ALARM LIST
5010 END OF RECORD The end of record (%) was specified.
5011 PARAMETER ZERO(CUT MAX) The maximum cutting feedrate (parameter No. 1422)is 0 in the HPCC
5046 ILLEGAL PARAMETER (ST.COMP) The parameter settings for straightness compensation contain an error.
Possible causes are as follows:
1. A parameter for a movement axis or compensation axis contains an
axis number which is not used.
2. More than 128 pitch error compensation points exist between the
negative and positive end points.
3. Compensation point numbers for straightness compensation are
not assigned in the correct order.
4. No straightness compensation point exists between the pitch error
compensation points at the negative and positive ends.
5. The compensation value for each compensation point is too large
or too small.
5051 M–NET CODE ERROR Abnormal character received (other than code used for transmission)
5052 M–NET ETX ERROR Abnormal ETX code
5053 M–NET CONNECT ERROR Connection time monitoring error (parameter No. 175)
5054 M–NET RECEIVE ERROR Polling time monitoring error (parameter No. 176)
5055 M–NET PRT/FRT ERROR Vertical parity or framing error
5057 M–NET BOARD SYSTEM DOWN Transmission timeout error (parameter No. 177)
ROM parity error
CPU interrupt other than the above
5064 DIFFERRENT AXIS UNIT (IS–B,
Circular interpolation has been specified on a plane consisting of axes
having different increment systems.
5065 DIFFERENT AXIS UNIT (PMC AXIS) Axes having different increment systems have been specified in the
same DI/DO group for PMC axis control. Modify the setting of parameter
5073 NO DECIMAL POINT No decimal point has been specified for an address requiring a decimal
5074 ADDRESS DUPLICATION ERROR The same address has been specified two or more times in a single
block. Alternatively, two or more G codes in the same group have been
specified in a single block.
5082 DATA SERVER ERROR This alarm is detailed on the data server message screen.
5134 FSSB : OPEN READY TIME OUT Initialization did not place FSSB in the open ready state.
5135 FSSB : ERROR MODE FSSB has entered error mode.
5136 FSSB : NUMBER OF AMPS IS SMALL In comparison with the number of controlled axes, the number of amplifi-
ers recognized by FSSB is not enough.
5137 FSSB : CONFIGURATION ERROR FSSB detected a configuration error.
5138 FSSB : AXIS SETTING NOT COM-
In automatic setting mode, axis setting has not been made yet.
Perform axis setting on the FSSB setting screen.
5139 FSSB : ERROR Servo initialization did not terminate normally.
The optical cable may be defective, or there may be an error in connec-
tion to the amplifier or another module.
Check the optical cable and the connection status.
5197 FSSB : OPEN TIME OUT The CNC permitted FSSB to open, but FSSB was not opened.
5198 FSSB : ID DATA NOT READ Temporary assignment failed, so amplifier initial ID information could not