OPERATION
B–63684EN/01
8. DATA INPUT/OUTPUT
507
Input/output–related parameters can be set on the ALL IO screen.
Parameters can be set, regardless of the mode.
Setting input/output–related parameters
1 Press function key
SYSTEM
.
2 Press the rightmost soft key (next–menu key) several times.
3 Press soft key
[ALL IO] to display the ALL IO screen.
NOTE
1 If program or floppy is selected in EDIT mode, the program
directory or floppy screen is displayed.
2 When the power is first turned on, program is selected by
default.
READ/PUNCH (PROGRAM) O1234 N12345
MDI
**** *** *** ***
12:34:56
PRGRM PARAM OFFSET (OPRT)
I/O CHANNEL 3 TV CHECK OFF
DEVICE NUM. 0 PUNCH CODE ISO
BAUDRATE 4800 INPUT CODE ASCII
STOP BIT 2 FEED OUTPUT FEED
NULL INPUT (EIA) NO EOB OUTPUT (ISO) CR
TV CHECK (NOTES) ON BAUDRATE CLK. INNER
CD CHECK (232C) OFF RESET/ALARM ON
PARITY BIT OFF SAT COMMAND HOST
INTERFACE RS422 COM PROTCOL A
END CODE EXT COM CODE ASCII
(0:EIA 1:ISO)>1_
MACRO
NOTE
Baud rate clock, CD check (232C), reset/alarm report, and
the parity bit for parameter No. 134, as well as the
communication code, end code, communication protocol,
interface, and SAT command for parameter No. 135 are
displayed only when channel 3 is being used for
input/output.
4 Select the soft key corresponding to the desired type of data (program,
parameter, and so forth).
5 Set the parameters corresponding to the type of input/output unit to be
used. (Parameter setting is possible regardless of the mode.)
8.11.1
Setting
Input/Output–Related
Parameters
Procedure