OPERATION
B–63684EN/01
12. GRAPHICS FUNCTION
665
(f) Automatic deletion
1 : Previously drawn figures are automatically deleted when automatic
operation is started in the reset state.
0 : Previously drawn figures are not automatically deleted.
(g)Drawing start position
When a coordinate system command, G92, is not specified in a
drawing program, this parameter specifies the drawing start position
using the coordinates in the workpiece coordinate system.
(Setting: 0 to"99999999, unit is specified in the parameter)
NOTE
The drawing start position cannot be specified for the
Z-axis, however.
(h)Blank length
This parameter specifies the blank length along the X-axis and Y-axis.
Setting this parameter draws a blank figure when the drawing screen
is selected or when the drawing soft key [ERASE] is pressed.
The end of the blank figure in the drawing plane described in (a) is used
as the origin of the workpiece coordinate system.
(Setting: 0 to"99999999, unit is specified in the parameter)
GRAPHIC O1234 N00200
X 0.000
Y 0.000
123.076
MEM **** *** *** 16:24:05
[ START ][ STOP ][ SBK ][ SEQ. ][ ERASE ]
Y
X