8. DATA INPUT/OUTPUT
9 During loading, the message ”RUNNING” blinks, and the number of
bytes loaded is displayed in the message field.
10 Upon the completion of loading, the message ”COMPLETED” is
displayed in the message field, with the message ”PRESS RESET
KEY.” displayed on the second line.
11 Press the RESET key. The messages are cleared from the screen.
To cancel file load prior to its completion, press the
key on the MDI
Depending on the type of data, the system power may have to be turned
off, then back on, for the load to become effective. When necessary, the
message ”TURN OFF POWER.” is displayed in the message field.
Before performing parameter/PMC data load, enable parameter write.
Before performing program/offset data load, set the data protection key,
on the machine operator’s panel, to the ON position.
When multiple files are to be loaded from multiple memory cards, a
message requesting memory card replacement is displayed.
If the saved data and CNC system onto which the saved
data is to be loaded do not satisfy the conditions described
below, an error message is displayed in the message field,
and loading is disabled. Note, however, that in selective
loading, even if the CNC system structure differs from that
of a saved file, the file is never the less loaded.
⋅ The size of a saved file does not match the size of CNC
⋅ The saved file has a different extension.
D Canceling loading
D Turning off the power
D Parameter/PMC data
D Program/offset data
D Loading files from
multiple memory cards