PROGRAMMING
12. COMPENSATION FUNCTION
B–63664EN/02
152
Offset calculation is carried out in the plane determined by G17, G18 and
G19, (G codes for plane selection). This plane is called the offset plane.
Compensation is not executed for the coordinate of a position which is not
in the specified plane. The programmed values are used as they are.
In simultaneous 3 axes control, the beam path projected on the offset plane
is compensated.
The offset plane is changed during the offset cancel mode. If it is
performed during the offset mode, a P/S alarm (No. 37) is displayed and
the machine is stopped.
In cutter compensation mode, spatial circular interpolation, spatial corner
R insertion, and three–dimensional conversion cannot be performed.
D Plane selection and
vector
Limitations