PROGRAMMING
B–63664EN/02
12. COMPENSATION FUNCTION
199
NOTE
1 When a G28, G30, or G30.1 command specifies an axis that is not in the cutter compensation
C plane, a perpendicular vector is generated at the end point of the previous block, and the tool
does not move. In the next block, offset mode is automatically resumed (in the same way as
when two or more continuous blocks do not specify any move commands).
Example: When CCN (bit 2 of parameter No. 5003) = 1
2 When a G28, G30, or G30.1 block is specified such that the block becomes a start–up block,
a vector perpendicular to the move direction is generated at an intermediate position, then
subsequently canceled at the reference position. In the next block, an intersection vector is
generated.
Example: When CCN (bit 2 of parameter No.5003)=1
s
G28(G30/30.1)Z__
G01
(G41G01X_Y_)
r
s
s
[FS15 Type]
G01
[FS15 Type]
G01
r
s
G42G28
s
s
G01
G01
s
Reference position or floating
reference position
Intermediate position