OPERATION
4. AUTOMATIC OPERATION
B–63664EN/02
528
(1)The memory card can not be accessed, such as display of memory card
list and so on, during the DNC operation with memory card.
(2)It is possible to execute the DNC operation with memory card on multi
path system. However, it is not possible to call programs from the
plural paths at the same time.
(3)The selection of DNC operation file that is set at DNC OPERATION
screen is cleared by the power supply turn off and on. After the power
supply is turned on again, it is necessary to select the DNC operation
file again.
(4)Please do not pull out and insert memory card during the DNC
operation with memory card.
(5)It is not possible to call a program in the memory card from the DNC
operation program.
(6)In case of using this function, the PMCIA card attachment written at
section 6 must be used to prevent a poor connection of the memory
card from occurring by vibration of the machine.
(7)In case of the stand–alone type i series that the display unit is a Display
link unit, this function can not be used.
(8)The memory card interface on the stand–alone type controller is not
available. Please use the memory card interface on the display unit.
#7
DNM0138
#6 #5 #4 #3 #2 #1 #0
[Data type] Bit
#7 (DNM) The DNC operation with memory card function is
0 : disable.
1 : enable.
4.12.3
Limitation and Notes
4.12.4
Parameter