OPERATION
B–63664EN/02
12. GRAPHICS FUNCTION
751
Set the machining direction of nozzle. The relationship between the
setting value and machining direction is as shown below.
P Machining direction of tools
0,1 Parallel to the Z–axis (perform machining from the + direction)
Set the dimensions of beam. The relationship between the displayed
address and setting value is as shown below:
Address Setting numerics
R Radius of beam
K Distance from the program point to nozzle tip (normally 0)
K
R
Program point
Tip of the nozzle
The relationship between graphic method and direction and setting value
is as shown below:
P Graphic method and direction
0, 4 Oblique projection view (+ X–axis)
1, 5 Oblique projection view (+ Y–axis)
2, 6 Oblique projection view (– X–axis)
3, 7 Oblique projection view (–Y–axis)
This setting value can also be incremented or decremented by the soft
keys
[+ROT] or [– ROT]. In this case, if the setting value exceeds 7, it
returns to 0. If it is smaller than 0, it becomes 7.
In addition, pressing the soft key
[+TILT] displays a top view and the soft
key
[– TILT] displays a solid drawing.
The vertical axis is fixed to the Z–axis.
D NOZZLE FORM
♦ Machining nozzle
orientation (P)
♦ Dimensions of beam
(R,K)
D PROJECTION
♦ Graphics method
and direction (P)
D VERTICAL AXIS